Dolmar MS-22C Manuel d'instructions télécharger pdf (Page 11)

Handling fuel

Utmost care is required when handling fuel. Fuel may contain substances

similar to solvents. Refuel either in a well ventilated room or outdoors. Do not

inhale fuel vapors, avoid any contact of fuel or oil with your skin.

Mineral oil products degrease your skin. If your skin comes in contact with

these substances repeatedly and for an extended period of time, it will

desiccate. Various skin diseases may result. In addition, allergic reactions

may occur. Eyes can be irritated by contact with oil. If oil comes into your

eyes, immediately wash them with clear water. If your eyes are still irritated,

see a doctor immediately.

Fuel and oil mixture

Inspect the fuel tank and fill with clean, fresh fuel of the proper

mixture to assure the longer life of the tool.

Use the following mixed gas.

Gasoline : DOLMAR genuine two-stroke engine oil = 50 : 1 or

Gasoline : Other Maker’s Two-stroke engine oil = 25:1

FUELS/REFUELING

When mixing gasoline with two-stroke engine oil. use only unleaded gasoline

which contains no ethanol, or methanol (type of alcohol).

This will help to avoid possible damage to engine fuel lines and other engine

parts.

Do not mix gasoline and oil directly in the fuel tank.

IMPORTANT: Failure to follow proper fuel mix instructions may cause damage

to the engine.

CAUTION: 1. When preparing fuel mixture, mix only the amount needed for

the job you aref to do.

Do not use fuel mixture that has been stored longer than two

months.

Fuel mixture stored longer than two months will cause hard

starting and poor performance.

If fuel mixture has been stored longer than this time, if should be

removed and filled with a fresh mixture.

2. Never fill the fuel tank to the very top.

3. Never add the fuel to the tank in a closed unventilatede area.

4. Do not add fuel to this unit close to an open fire or sparks.

5. Be sure to wipe off spilled fuel before attempting to start the

engine.

6. Do not attempt to refuel a hot engine.

Check points before operation

1. Check for loose bolts, nuts and fittings.

2. Check the air cleaner for dirt. Clean the air filter of all dirt, etc. before

operation

3. Check to be sure that protector is securely in place.

Refueling

The engine must be switched off.

– Thoroughly clean the area around the fuel filler cap (2), to prevent dirt from

getting into the fuel tank (1).

– Unscrew the fuel filler cap (2) and fill the tank with fuel.

– Tightly screw on the fuel filler cap (2).

– Clean screw fuel filler cap (2) and tank after refueling.

Storage of Fuel

Fuel cannot be stored for an unlimited period of time.

Purchase only the quantity required for a 4 week operating period. Only use

approved fuel storage containers.

Observe the Safety Instructions on page 4 !

FOR CALIFORNIA REGULATION:

THIS EQUIPMENT IS CERTIFIED TO OPERATE ON GASOLINE + TWO STROKE OIL

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 52 53

Commentaires sur ces manuels

Pas de commentaire

Dolmar MS-22C Manuel d'instructions Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Dolmar MS-22C